1. Manual argon tungsten arc welding
Tungsten argon arc welding non-consumable electrode arc welding is to use the arc generated between the tungsten electrode and the weldment to heat melt the joint of the weldment and fuse the weldment together. During the welding process, welding wire can be added or not, and the tungsten electrode, welding pool, the near seam area of the weld, and the melting end of the added welding wire should be protected by argon.
Generally, non-contact high-frequency arc striking is used for welding, and the arc length is controlled at 1.0 ~ 1.5 times the electrode diameter. The arc length of the fillet weld can be slightly longer, and the welding nozzle is inclined backward (reverse welding direction) by 75 degrees. Welding current is the most important technical parameter of arc welding, which has a direct impact on weld penetration, welding speed, deposited metal, and weld quality. TIG welding titanium is commonly used as the welding power source of the positive connection method, that is, the positive electrode is connected to the weldment and the negative electrode is connected to the welding handle. 30% of the heat energy generated by the arc of the positive connection method is concentrated on the tungsten electrode, and 70% of the heat energy is concentrated on the weldment, so the penetration is deeper than that of the reverse connection method. The arc from starting to extinguishing must match the argon supply and gas stop time, that is, the gas supply must be in advance before the arc is started, and the argon must lag the gas stop after the arc is extinguished.
2. Protective gas
Protective gas is sprayed from the welding nozzle, covering the entire length of the tungsten electrode and the molten pool area of arc melting, which is free from air pollution. The commonly used gas is inert gas argon or helium. The thermal conductivity of argon is small, and there is no decomposition and heat absorption under the action of the arc, so the heat loss of argon is less, and the arc voltage is low, about 8 ~ 15V. In addition to the purity of the shielding gas (greater than 99.98%), the protection effect is also related to the geometric size design of the welding nozzle, that is, it can ensure that the argon flow emitted by the welding nozzle is laminar rather than turbulent. Generally, the height of the welding nozzle is 1.5 times of the nozzle diameter.







